How to Replace Your Shower Trim PlateUpdated 17 days ago

This guide covers the removal of your old trim and the installation of the replacement plate.

Part 1: Removal Instructions

1. Loosen the Handles: Start by removing the decorative cover buttons found on the underside of the handles. Then, use the Allen wrench (2) to loosen the handle set screws.

2. Remove the Handles:

   • Slide the main valve handle (3) off of the square cartridge stem (4).

   • Slide the diverter handle (5) off of the splined cartridge stem (6).

3. Remove the Plate:

   • Once both handles are removed, pull the escutcheon plate (7) away from the wall.

   • To do this, start by releasing the top edge of the escutcheon, then pull it straight off the two valve bodies.

4. Clear Debris: If the old rubber gaskets remain stuck to the wall, remove them and set them aside.

Part 2: Installation Instructions

1. Prepare the New Plate: Confirm that the 2 rubber gaskets are firmly attached to the rear of the new escutcheon (8).

2. Mount the Plate:

   • Align the escutcheon plate so the smaller hole is positioned at the top.

   • Angle the top edge of the plate toward the wall (9) before pressing it in and onto the two valve bodies.

3. Reinstall Handles:

   • Slide the diverter handle (10) onto the splined cartridge stem (11).

   • Slide the main valve handle (12) onto the square cartridge stem (13).

4. Secure the Hardware: Insert the decorative cover buttons (14) into the underside of the handles. Use the Allen wrench (15) to tighten the handle set screws.

5. Ensure a Seal: Finally, press the escutcheon plate firmly against the wall surface to ensure a snug fit and moisture seal (16).

Need a hand?

We are here to help if you run into issues during installation.

• Phone Support: (854) 888-9231 (Available Mon-Fri, 9am-5pm ET)

• Email: [email protected]